Direct-to-Film (DTF) printing is changing the custom apparel game — vibrant colors, long-lasting results, and flexibility for almost any fabric. 💪✨

But here’s the thing: even the best transfers can fail if they’re not applied correctly. Cracking, peeling, fading… all of these are usually caused by simple application errors 😬

Let’s fix that! 🖤

🚫 Using the Wrong Temperature or Time

The mistake:
Pressing too hot, too cold, too long, or too short. This can cause transfers to burn, peel off early, or not adhere fully.

The fix:
✅ Follow the exact temperature, time, and pressure settings recommended.
✅ Use a heat press thermometer to make sure your platen is accurate.

💡 Pro Tip: Every heat press is slightly different — always run a test press before a big batch!

🚫 Uneven Pressure During Heat Pressing

The mistake:
Uneven pressure causes partial adhesion — edges lift up or peel after a few washes.

The fix:
✅ Apply medium to firm pressure evenly across the whole design.
✅ Avoid pressing over seams, zippers, or buttons that can throw off pressure.

📌 Use a pressing pillow or foam pad to even out bumpy areas.

🚫 Not Pre-Pressing the Garment

The mistake:
Skipping the pre-press can trap moisture and wrinkles, which stop the film from sticking.

The fix:
✅ Press the blank garment for 5–10 seconds before applying the transfer.
✅ This removes moisture and flattens the fabric.

💥 Final Thoughts

DTF printing is powerful — but only if done right. By avoiding these common mistakes, you’ll get flawless, long-lasting prints every time 🌟

At DTF Super Print, we use high-quality transfers and expert techniques to make sure your designs press perfectly and last for years. 💎

⚡ Ready to press like a pro?

Order your ready-to-press DTF transfers from us today and say goodbye to cracking, peeling, and wasted blanks! 🎨🖤